compatibility of deformation
英 [kəmˌpætəˈbɪləti ɒv ˌdiːfɔːˈmeɪʃn]
美 [kəmˌpætəˈbɪləti əv ˌdiːfɔːrˈmeɪʃn]
网络 变形协调
双语例句
- On the basis of the boundary conditions of the structure and compatibility conditions of deformation, combined with the generalized variational principle, each part of energy of beams and rails structure are calculated.
通过结构的边界和变形协调条件并运用广义变分法，再计算梁轨体系各部分的能量。 - On the Compatibility Condition of Displacement Field for Finite Deformation of Continuum
论连续体有限变形的位移协调条件 - Considering construction steps, to every step, nonlinear equations are proposed according to the compatibility of deformation of the intersection point between soil anchors and earth-retaining pile wall.
根据基坑开挖的施工过程，对每一个开挖步骤，利用锚杆和挡土桩交点变形协调关系建立协调方程组； - The compatibility of deformation may occur on tube thread according to dimension of collar thread, which is helpful in improving the connection quality.
油管螺纹与接箍螺纹联接后会发生变形协调，有利于提高螺纹联接质量。 - Based on the principle of compatibility of deformation, analytic solution for the temperature strain of carbon fiber reinforced concrete structural members is derived. Also Ansys software is used to make simulation analysis on temperature strain of carbon fiber polymer reinforced concrete structural members.
根据变形协调原理，推导了碳纤维布加固混凝土构件温度应力的解析解，并采用ANSYS软件对碳纤维布加固混凝土构件的温度应力进行了仿真分析。 - The experiment on bolt of compatibility and deformation is basilica for mechanics. On the Compatibility Condition of Displacement Field for Finite Deformation of Continuum
螺栓变形协调实验是机械类专业的一项重要实验。论连续体有限变形的位移协调条件 - The basic idea is as follows: the redundant bending moment is assumed at a virtual hinge at the middle support and calculated using compatibility condition of deformation.
基本思路：在中间支座设虚铰代之以冗力弯矩，并利用变形协调条件求出该值； - Considering that there was dummy shear zone between pile-soil interface, the compatibility equation of pile-soil was built up with extended compatibility deformation equation based on displacement solution of Mindlin.
考虑桩土作用界面存在虚拟剪切带，基于Mindlin位移解，用广义协调变形方程建立桩与土之间的协调方程。 - On the basis of the analysis on achievements and amount of testing data, through the internal force equilibrium and deformation compatibility of cross section, a simple method based on the global deformation is derived to calculate the ultimate load-carrying capacity of external prestressing concrete beams.
在分析国内外研究成果和大量试验数据的基础上，通过截面的内力平衡方程和变形协调关系，从结构的整体变形入手，推导出计算体外预应力混凝土简支梁极限承载力的实用计算公式。 - Elasto-plastic analysis for vertical pile based on extended compatibility of deformation
基于广义协调变形的直桩弹塑性分析 - The frictional characters, the influence of material compatibility, the effect of NBR deformation on the starting frictional drag of friction pairs used in ASP flooding are investigated.
探讨了丁腈橡胶在三元复合驱液中的摩擦过程特征、材料匹配性的影响和橡胶变形量对摩擦副启动摩擦阻力的影响。 - No matter how complex the edge conditions are, it is not difficult to set up the equations of compatibility of deformation, therefore the internal forces of oblique intersection beams under various support conditions can be analyzed.
由于不论如何复杂的边界条件，列变形谐调方程都不困难，所以用荷载分配法可解各类支承条件斜放类交叉梁系的内力。 - Equation of balance, equation of motion, equation of compatibility and constitution equation of couple stress theory are derived in both plane strain deformation and plane stress deformation. For the convenience of discussing, elasticity couple stress theory in plane stress deformation is studied in the paper.
研究并推导了平面应力及平面应变状态下偶应力理论的本构关系和控制方程，本文为讨论方便仅详细讨论了平面应力变形下弹性偶应力理论的情况。 - Compatibility of deformation lead to stress redistribution, The higher WC content have, the larger stress experience. Fracture occurs in high WC content layer first, and then extend to the low WC content layer.
由于变形协调导致应力重分配，使得高WC含量的层所承受的应力较大，首先开裂，随后裂纹再向低WC层扩展。 - This topic combining with elastic-plastic theory and deformation compatibility condition establish a model to solve the load distribution of the ball screw. And the contact deformation and axial contact stiffness of the ball screw are analyzed based on this research.
本文结合弹塑性理论以及变形协调条件建立了求解滚珠丝杠副载荷分布的模型，以此为基础重点研究了滚珠丝杠副的接触变形及轴向接触刚度，并对相关结构参数进行优化。 - The techniques not only accounts for the compatibility of generalized displacements and generalized stresses on the interface both the elastic layers and piezoelectric layers, but also the rotary inertia of laminate and the transverse shear deformation are considered in the general equation of structure.
该方法不仅考虑了弹性层和压电层界面间广义位移和广义应力的连续性，还考虑到了结构的转动惯量和剪切变形。 - By analyzing the stress characteristic of structure of self-anchored suspension bridges, the dissertation obtains a synthesis method to determine hangers inner force on the basis of least-energy principle and compatibility of deformation.
验证了自锚式悬索桥施工控制中的力学特性，在对自锚式悬索桥结构受力特性进行分析的基础上，推导了基于最小能量原理与变形协调法综合确定自锚式悬索桥的吊杆内力。 - The deduction shows that the minimum plastic complementary energy principle is centralized reflection of equilibrium condition, deformation compatibility condition and constitutive relation.2.The monolithic stability of high arch dams is evaluated using the deformation reinforcement theory.
推导表明，最小塑性余能原理是结构平衡条件、变形协调条件和本构关系的集中体现。2.运用变形加固理论，采用工程类比的方法评价高拱坝的整体稳定性。